Drywall and Sheetrock Repair

Drywall (also known as plasterboard, wallboard, gypsum board, or LAGYP) is a panel made of gypsum plaster pressed between two thick sheets of paper. It is used to make interior walls and ceilings. Drywall construction became prevalent as a speedier alternative to traditional lath and plaster

When holes appear in Drywall

Drywall and Sheetrock (also known as plasterboardwallboardgypsum board, or LAGYP) is a panel pressed between two thick sheets of paper. It is used to make interior walls and ceilings. When holes appear in Drywall, it will need to be repaired.  Here are some instructions on carrying out a successful Drywall repair also know as sheet-rock repair:

Tools and Materials Needed

  • 1 1/4″ drywall screws.
  • Square section of drywall exceeding the size of the hole by at least two inches on all sides.
  • Framing square (optional)
  • Drywall mesh joint tape.
  • Utility knife.
  • Cordless drill.
  • Drywall saw (or jigsaw with coarse blade).
  • Drywall joint compound (not spackle).
  • Two strips of plywood or other thin wood about two inches wide. Length of these strips is determined by adding six inches to the diameter of the hole being repaired.

How To Do It

  1. Cut away any stray, loose paper parts around the hole to be repaired. If any chunks of drywall are hanging, remove them as well.
  2. With the framing square, or simply by eyeballing it, draw a square around the hole. The lines should extend about 1/2″ past the edges of the hole.
  3. With the drywall saw or jigsaw, cut along the lines of your square.
  4. Cut your two plywood strips so that they are three inches longer — on each end of the strip — than the hole (i.e., your newly created square).
  5. Insert the strips behind the hole, within the wall cavity.
  6. With the cordless drill, drive the 1 1/4″ screws through the wall and into the wood strips. Essentially, you are building a framework of these two strips for the new piece of drywall to rest on.
  7. With the jigsaw or hand saw, cut your extra piece of drywall so that it exactly fits into your newly created “square hole.”
  8. Screw into the wood strips. Four screws are sufficient.
  9. Apply drywall mesh tape over the seams.
  10. At this point, fill over mesh tape with joint compound. Let dry, then sand. Fill in once again, dry, and sand until smooth.
Find us on Google+